ASTM D93

ASTM D93

ASTM D93 free download pdf

ASTM D93 – STANDARD TEST METHODS FOR FLASH POINT BY PENSKY-MARTENS CLOSED CUP TESTER
Revision / Edition: 08 Chg: Date: 10/15/08 ASTM D93

Document Abstract
These ASTM D93 test methods cover the determination of the flash point of petroleum products in the temperature range from 40 to 360°C by a manual Pensky-Martens closed-cup apparatus or an automated Pensky-Martens closed-cup apparatus, and the determination of the flash point of biodiesel in the temperature range of 60 to 190°C by an automated Pensky-Martens closed cup apparatus.

NOTE 1 ”Flash point determination as above 250°C can be performed, however, the precision has not been determined above this temperature. For residual fuels, precision has not been determined for flash points above 100°C. ASTM D93, The precision of in-use lubricating oils has not been determined. Some specifications state a D93 minimum flash point below 40°C, however, the precision has not been determined below this temperature.

Procedure A is applicable to distillate fuels (diesel, biodiesel blends, kerosine, heating oil, turbine fuels), new and in-use lubricating oils, and other homogeneous petroleum liquids not included in the scope of Procedure B or Procedure C.

ASTM D93, Procedure B is applicable to residual fuel oils, cutback residua, used lubricating oils, mixtures of petroleum liquids with solids, petroleum liquids that tend to form a surface film under test conditions, or are petroleum liquids of such kinematic viscosity that they are not uniformly heated under the stirring and heating conditions of Procedure A.

Procedure C is applicable to biodiesel (B100). ASTM D93, Since a flash point of residual alcohol in biodiesel is difficult to observe by manual flash point techniques, automated apparatus with electronic flash point detection have been found suitable.

These test methods is applicable for the detection of contamination of relatively nonvolatile or nonflammable materials with volatile or flammable materials.

The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

NOTE 2 ”It has been common practice in flash point standards for many decades to alternately use a C–scale or an F–scale thermometer for temperature measurement. ASTM D93, Although the scales are close in increments, they are not equivalent. Because the F–scale thermometer used in this procedure is graduated in 5° increments, it is not possible to read it to the 2°C equivalent increment of 3.6°F

Therefore, for the purposes of application of the procedure of the test method for the separate temperature scale thermometers, different increments must be used. In this test method, the following protocol has been adopted: When a temperature is intended to be a converted equivalent, it will appear in parentheses following the SI unit, for example 370°C (698°F). When a temperature is intended to be a rationalized unit for the alternate scale, it will appear after “or,” for example, 2°C or 5°F.

This standard does not purport to address all of the safety concerns, if any, associated with its use. ASTM D93, It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.4, 7.1, 9.3, 9.4, 11.1.2, 11.1.4, 11.1.8, 11.2.2, and 12.1.2

File Type Download : PDF File, ASTM D93



read omega by sm reine online free, astm f1980 pdf, Steel BS 970 and Equivalent astm grades, sphc material equivalent, BS S151D, ASTM D93 pdf, astm equivalent to bs970 uk spec, ASTM-D93, bs 4360 gr 43a, BS 970 220M07 gb ml08aj