ASTM D92

ASTM D92

ASTM D92 free download pdf

ASTM D92 – STANDARD TEST METHOD FOR FLASH AND FIRE POINTS BY CLEVELAND OPEN CUP TESTER
Revision / Edition: 05A Chg: Date: 07/01/05 ASTM D92

Document Abstract
This ASTM D92 test method describes the determination of the flash point and fire point of petroleum products by a manual Cleveland open cup apparatus or an automated Cleveland open cup apparatus.

NOTE 1 – The precisions for fire point were not determined in the current interlaboratory program. Fire point is a parameter that is not commonly specified, although in some cases, knowledge of this flammability temperature may be desired.

This ASTM D92 test method is applicable to all petroleum products with flash points above 79°C (175°F) and below 400°C (752°F) except fuel oils.

NOTE 2 – This test method may occasionally be specified for the determination of the fire point of a fuel oil. For the determination of the flash points of fuel oils, use Test Method ASTM  93. Test Method D 93 should also be used when it is desired to determine the possible presence of small, but significant, concentrations of lower flash point substances that may escape detection by Test Method D 92. Test Method D 1310 can be employed if the flash point is known to be below 79°C (175°F).

The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This ASTM D92 standard does not purport to address all of the safety concerns, if any, associated with its use,  It is the responsibility of the user of this ASTM D92 standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.4, 7.1, 11.1.3, and 11.2.4.

Footnote * – A Summary of Changes section appears at the end of this ASTM D92 standard

File Type Download : PDF File, ASTM D92



astm d92, what is ASTM D92 for