ASTM d 882

ASTM d 882

ASTM d 882 pdf free download

Historical Standard: ASTM D882-09 Standard Test Method for Tensile Properties of Thin Plastic Sheeting
ASTM d 882
1. Scope ASTM d 882 pdf
1.1 This test method covers the determination of tensile properties of plastics in the form of thin sheeting, including film (less than 1.0 mm (0.04 in.) in thickness).

 

Note 1—Film has been arbitrarily defined as sheeting having nominal thickness not greater than 0.25 mm (0.010 in.).

Note 2—Tensile properties of plastics 1.0 mm (0.04 in.) or greater in thickness shall be determined according to Test Method D 638.

1.2 This test method may be used to test all plastics within the thickness range described and the capacity of the machine employed.

1.2.1 Static Weighing, Constant-Rate-of-Grip Separation Test—This test method employs a constant rate of separation of the grips holding the ends of the test specimen.

1.3 Specimen extension may be measured in these test methods by grip separation, extension indicators, or displacement of gage marks.

1.4 A procedure for determining the tensile modulus of elasticity is included at one strain rate.

Note 3—The modulus determination is generally based on the use of grip separation as a measure of extension; however, the desirability of using extensometers, as described in 5.2, is recognized and provision for the use of such instrumentation is incorporated in the procedure.

1.5 Test data obtained by this test method is relevant and appropriate for use in engineering design.

1.6 The values stated in SI units are to be regarded as the standard. The values in parentheses are provided for information only.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 4—This test method is similar to ISO 527-3, but is not considered technically equivalent. ISO 527-3 allows for additional specimen configurations, specifies different test speeds, and requires an extensometer or gage marks on the specimen.

2. Referenced Documents (purchase separately)

ASTM Standards

D618 Practice for Conditioning Plastics for Testing
D638 Test Method for Tensile Properties of Plastics
D883 Terminology Relating to Plastics
D4000 Classification System for Specifying Plastic Materials
D5947 Test Methods for Physical Dimensions of Solid Plastics Specimens
D6287 Practice for Cutting Film and Sheeting Test Specimens
D6988 Guide for Determination of Thickness of Plastic Film Test Specimens
E4 Practices for Force Verification of Testing Machines
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ISO Standard

ISO527-3 Plastics–Determination of Tensile Properties–Part 3: Test Conditions for Films and Sheets

Index Terms

modulus of elasticity; plastic film; plastic sheeting; tensile properties; tensile strength; toughness; yield stress; Plastic sheet and film; Tensile properties/testing–plastics; Thin sheeting; Modulus of elasticity–plastics; Toe compensation; Toughness; Yield stress;

File Type Download : PDF File, ASTM d 882



astm d 882, what is ASTM-D-882 in pet film, hdpe modulus vs temperature, modulus of elasticity chart for metals, modulus of elasticity for a36 steel, young\s modulus of pe 4710 hdpe pipes, modulus of elasticity OF SA-516 GRADE 70, pilipino module 10, sa-516-70 modulus, steel and modulus of elasticity chart