ASTM C31 STANDARD PRACTICE FOR MAKING AND CURING CONCRETE TEST SPECIMENS INTHE FIELD
Revision Edition 09 Chg: Date: 05/01/09 ASTM C31
This ASTM C31 practice covers procedures for making and curing cylinder and beam specimens from representative samples of fresh concrete for a construction project.
The concrete used to make the molded specimens shall be sampled after all on-site adjustments have been made to the mixture proportions, including the addition of mix water and admixtures. ASTM C31, This practice is not satisfactory for making specimens from concrete not having measurable slump or requiring other sizes or shapes of specimens.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
This ASTM C31 standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to exposed skin and tissue upon prolonged exposure.2)
The text of this ASTM C31 standard references notes which provide explanatory material. These notes shall not be considered as requirements of the standard.
2 See Section on Safety Precautions, Manual of Aggregate and Concrete Testing, Annual Book of ASTM Standards, Vol. 04.02.
*A Summary of Changes section appears at the end of this ASTM C31 standard