ASTM A635

ASTM A635

ASTM A635 pdf free download

ASTM A635 Standard Specification for Steel, Sheet and Strip, Heavy-Thickness Coils, Hot-Rolled, Alloy, Carbon, Structural, High-Strength Low-Alloy, and High-Strength Low-Alloy with Improved Formability, General Requirements for
ASTM International / 01-May-2009 / 10 pages ASTM A635-09 pdf

1.1 This ASTM A635 specification covers the general requirements for hot-rolled, heavy-thickness sheet and strip in coils.1.2 It applies to Specification A 1018/A 1018M.

1.3 This material is available only in coils described as follows:

Size Limits, Coils Only
Product Width, in. [mm] Thickness, in. [mm]
Strip over 8 to 12, incl
[over 200 through 300] 0.230 to 1.000, incl
[from 6.0 through 25]
Sheet All WidthsA
All Widths 0.230 to 1.000, incl
[from 6.0 through 25]

A Hot-rolled heavy thickness sheet in coils less than 12 in. [300 mm] and less in width must have slit edges. Hot-rolled heavy thickness coils 12 in. [300 mm] and wider with mill edge is considered hot-rolled heavy thickness strip.

Note 1 – The changes in width limits with the publication of A 635/A 635M – 06a result in a change in tensile testing direction for material from 0.180 in. [4.5 mm] to 0.230 in. exclusive [6.0 mm exclusive] over 48 in. [1200 mm] wide as that material is now covered by Specification A 568/A 568M – 06a. The purchaser is advised to discuss this change with the supplier.

1.4 In case of any conflict in requirements, the requirements of the individual material specification shall prevail over those of this general specification.

1.5 Annex A1 lists permissible variations in dimensions and mass (see Note 2) in SI [metric] units. The values listed are not exact conversions of the values listed in the inch-pound tables, but instead are rounded or rationalized values. Conformance to Annex A1 is mandatory when the “M” specification is used.

Note 2 – The term weight is used when inch-pound units are the standard. However, under SI, the preferred term is mass.

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.7 This ASTM A635 specification and the applicable material specifications are expressed in both inch-pound units and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units.

Keywords ASTM A635-09: carbon ; commercial; drawing; heavy thickness coils; high-strength low-alloy; high-strength low-alloy with improved formability; sheet steel; strip steel; Carbon steel sheet/strip–specifications; Commercial steel (CS) sheet/strip–specifications; General delivery requirements–steel; Heavy-thickness steel coils–specifications; High-strength structural steel–specifications; Hot-rolled steel sheet/strip–specifications; Structural steel (SS) sheet/strip–specifications; ICS Number Code 77.140.50 (Flat steel products and semi-products), ASTM A635-09.

File Type Download : PDF File, ASTM A635



a635 steel, ASTM A635, astm a635 stock, astm a635 vs a36