ANSI Z245.30 2008

ANSI Z245.30 2008

ANSI Z245.30 2008

ANSI Z245.30 2008 Waste Containers – Safety Requirements
American National Standards Institute / 15-Jan-2008 / 45 pages

This ANSI Z245.30 2008 standard establishes safety requirements with respect to the manufacture, reconstruction, use, modification, maintenance, service, operation, and installation (where applicable) of containers, two-wheeled carts, and two-wheeled cart lifters.

American National Standard
ANSI Z245.30 2008
ENVIRONMENTAL INDUSTRY
ASSOCIATIONS
for Equipment Technology and
Operations for Wastes and
Recyclable Materials Waste Containers Safety Requirements

Table of Contents ANSI Z245.30 2008
Page
Foreword (informative)…iii
0 Introduction (informative) ……………………… 1
1 Scope.. 1
2 Normative references….. 5
3 Definitions…………………. 5
4 Construction, installation, reconstruction, and modification
4.1 Design……………………… 10
4.2 Markings…………………… 10
4.3 Installation of containers and lifters ………… 11
4.4 Reconstruction and repair …………………….. 11
4.5 Modification ………………. 11
5 Manufacturer/rebuilder/modifier responsibilities
5.1 Documented instructions 11
6 Employer, owner, and other user’s responsibilities for containers
6.1 Employee responsibilities for all containers ……………………… 11
6.2 Operator or employee responsibilities for all containers …….. 15
7 Technical requirements
7.1 General safeguards and features…………… 17
7.2 Safeguards and features for specific container types ………… 21

Appendices (normative) ANSI Z245.30 2008
A Volumetric loading capacity test methods for carts ……………. 29
B Slope stability test method for carts ……….. 30
C Durability during pulling test for carts ……… 31
D Loading and unloading test for carts ………. 32
E Center-of-balance position test for carts …. 33
F Force to tip test for carts. 34
G Lid test for carts…………. 35
Annex
A Bibliography (informative) …………………… 36

AMERICAN NATIONAL STANDARD ANSI Z245.30 2008
Figures ANSI Z245.30 2008
1a Typical refuse containers . 2
1b Typical refuse containers . 3
2 Refuse containers not included ……………….. 4
3 Roll-off/hoist type equipment…………………. 10
4 Container wheelbase…… 10
5 Markings for containers three meters or greater ……………….. 14
6 Markings for containers less than three meters ………………… 14
7a Container label (caution, falling hazard)….. 19
7b Container label (caution, falling hazard)….. 19
7c Container label (warning, striking hazard).. 20
8 Typical four-wheeled or slant-sided containers …………………. 23
9 Shift of load center of gravity in four-wheeled containers……. 24
10 Conditions for testing in most unstable condition ………………. 25
11 Approximate location of safety markings…. 26
12 Container safety sign…… 31

File Type Download : PDF File, ANSI Z245.30 2008



ansi z1 4 2008 free sampling table, ANSI ASQ Z1 4 2008 Free, Z245 21-2008, ANSI Z1 4 2008 Free Download, ansi z245 30, ansi/asq z1 4 2008 free download, CSA Z245 11 Free Download, ansi z245 1-2007, ANSI Standard Z245 1-1999, ANSI 156 3-2008